GYS MULTIPEARL 210-2 Manual De Instrucciones página 24

Translation of the original instructions
The device is designed with a quick release gas connection. Use the adaptor supplied with the machine.
FE
Type of wire
MAG
Process
Ar+CO²
Gas
0.6 - 0.8
Ø available
- 1.0
Welding
All
position
MMA
• Selecting MMA mode
• Welding current adjustment
• Arc Force adjustment
• Hot Start adjustment
ELECTRODE WELDING
• The reverse polarity cable must be disconnected in MMA (stick welding) mode in order to connect the electrode holder and earth
clamp. Connect the electrode holder and earth clamp as indicated on the electrode packaging.
• Respect the basic rules of welding
• This device has 3 features specific to Inverter machines :
- Hot Start: Increases the current to assist the initial striking of the arc.
- Arc Force: A ponctual increase of current avoiding the electrode to be stuck in the welding pool.
- Anti-Sticking: Enables easy removal of the electrode from the metal.
TIPS :
Low Hot Start for thin metal sheet and high Hot Start for more difficult metal to weld (dirty metal or oxidised).
TIG PRO (EURO TORCH)
• Selecting TIG Pro mode (Euro torch)
24
MULTIPEARL 210-2 / 210-4 XL / 211-4
FE AlMg 5 SS
MAG MIG MAG
CO² Ar
Ar+CO² 2%
0.6 - 0.8
0.8 - 1.0 0.8 - 1.0
- 1.0
All All All
Keep button 2 pressed and at the same
time turn the upper knob to select MMA
mode.
Turn the upper knob to select the wel-
ding current.
Turn the lower knob to adjust the Arc
Force.
Adjustable from 0 to 100%
Keep pressing button 3 and at the same
time turn the upper knob to adjust the
Hot Start.
Adjustable from 0 to 100%
Keep button 2 pushed and at the same
time turn the upper knob until «TIG Pro»
is displayed.
FC CuSi 3 CuAL 8
MAG MIG MIG
Ar Ar
0.6 - 0.9
0.8 0.8
-1.2
All All All
ALSi 5 ALSi 12
MIG MIG
Ar Ar
1.0 1.0
All All
+
+
+
EN