GYS MULTIPEARL 210-2 Manual De Instrucciones página 26

Translation of the original instructions
Adjustable Downslope (Euro torch only)
Time needed to shift from welding current to minimum current. Avoids cracks and craters at the end of welding. By default this fea-
ture is set up at 0 sec.
Adjustable Post-Gas (Euro torch only)
This parameter determines the time in which gas is released after the arc has stopped. It protects the weld pool and the electrode
against oxidisation whilst the metal is cooling after welding.
Recommended settings / Electrode grinding
0,5-5
4-7
To optimise the welding process, it is recommended to grind the electrode prior to welding as described in the diagram below
DUTY CYCLE AND WELDING ENVIRONMENT
• The machine has a specification with a "dropping current output" (MMA & TIG). The machine has a specification with a "constant
current output" (MIG). Its duty cycle following the norm EN60974-1 is indicated in the table below :
X / 60974-1 @ 40°C (T cycle = 10 min)
MIG-MAG
MMA
TIG
MIG-MAG
MMA
TIG
THERMAL PROTECTION AND GUIDANCE
While under intensive use (superior to the duty cycle) the thermal protection can activate, in that case, the arc switches off and the
thermal protection indicator switches on.
• Ensure the machine's vents are clear enabling air circulation.
• Leave the device plugged in after welding to enable cooling.
In general :
• Respect the basic rules of welding.
• Ensure the air circulation is good.
• Do not work in a wet area.
26
MULTIPEARL 210-2 / 210-4 XL / 211-4
ø Electrode (mm) = ø
Current (A)
10-130
130-190
L=2,5xd
I max
200A @ 20%
200A @ 18%
200A @ 22%
150A @ 22%
130A @ 22%
160A @ 20%
ø Nozzle (mm)
wire (filler rod)
1,6
2,4
60% (T cycle = 10 min)
130 A
110 A
135 A
100 A
90 A
115 A
Flow (Argon L/min)
9,8 6-7
11 7-8
100% (T cycle = 10 min)
110 A
90 A
115 A
90 A
75 A
100 A
EN