Garland AMAZON 350 E Manual De Instrucciones página 23

Buoy lock:
You can lock the buoy so that
it is always running by holding
the buoy as indicated in figure
4. This lock is useful when you
want to suck in every last mm
of water.
Water height regulation:
Adjusting the length of the buoy
cable we can adjust when we
want the pump to start / stop
depending on the water height
It is important to always leave at
least 5 cm of free cable between
the buoy and the attachment
point so that the buoy has
sufficient movement capacity.
5.3. CHECKING POINTS BEFORE SUBMERGING THE
PUMP
It is important to check that all parts are well
tightened. Tighten, repair and replace all necessary
before using the machine.
5.4. PUMP SUBMERSION
Place the pump in the water by holding the
transport handle and ensuring the machine is in a
vertical position. The pump can be placed on the
bottom of the surface if the water is clean and has
no impurities. If not, the machine must be placed on
a platform.
If you cannot reach the bottom with your arm, you
can tie a rope to the transport handle and lower the
pump. The same rope can later be used to raise the
pump. Never use the buoy to lower or raise the pump.
6. MACHINE USAGE
been designed. The use of this machine for any other
jobs is dangerous and can cause dangers to the users
and/or to the machine.
Do not rely solely on the security elements of the
machine.
Do not use this machine if tired, ill or if under the
effects of medicines, alcohol or drugs. The lack of rest
5 cm
and fatigue can cause accidents and damages.
Do not use this machine at night, with fog or with
reduced visibility that does not allow you to clearly see
the working area.
Always be alert that the machine has no loose parts.
If you detect any loose parts, stop the machine
immediately and check the machine carefully. If you
detect any problems, stop the machine and take to
your nearest service dealer. Never carry on working
with the machine.
6.1. START AND STOPPAGE
The machine starts and stops automatically
depending on the position of the buoy once the
machine has been connected to the mains. This
machine has no manual switch.
6.2. CONNEXION TO THE MAINS
It is obligatory to connect the machine to a mains
switch protected by a residual differential equal to or
less than 30mA. Electricity tension should be 230v,
frequency 50Hz and have a magnet and thermal
switch between 10A-16A.
23/88
Use this machine only for jobs for which it has
English