Publicidad
Basic Saw Operations
Sliding Base/Fence Extension
Extend and use sliding base/fence when
!
WARNING
making severe bevel, severe miter or
compound cuts to provide sufficient (minimum 6") spacing
from hand to saw blade.
Sliding Base:
Loosen the thumbscrew 1 in sliding base channel
1.
(Figure 24).
Slide sliding base/fence 2 to the desired position.
2.
3.
Tighten thumbscrew 2.
Sliding Fence:
Unlock the fence locking lever 3 (Figure 25).
1.
2.
Slide fence to proper position 4.
3.
Relock fence in place.
4.
Move the head assembly to check clearance with fence.
During transportation, sliding base and
!
CAUTION
fence should always be secured in the full
in position.
Stop Block:
Stop block can be used to make repetitive length cuts.
1.
Attach stop block 5 to extension rail 6 (Figure 26).
2.
Loosen thumbscrew 7 on backside of stop block 5.
3.
Slide stop block to desired length of cut.
4.
Tighten thumbscrew.
Note: Stop block can be stored by loosening knob and
flipping stop block.
Crown stops:
Crown stops assists in holding crown molding in place during
cutting operation.
Remove stop block 5 and extension rail 6 (Figure 27).
1.
2.
Place washer onto 8 onto lock knob 9.
Align crown stop 10 with hole in the side of base, and
3.
thread washer 8 and lock knob 9 into hole provided.
Your tool is equipped with two crown stops, one for each side
of the table. Repeat steps 1 through 3 on opposite side.
FIG. 24
FIG. 25
FIG. 26
5
FIG. 27
10
9
8
50
2
1
4
3
7
6
Publicidad
