Publicidad
Idiomas disponibles
Idiomas disponibles
blade, ensure there is no sudden impact at the beginning of the
cutting operation.
4. As shown in Figure 8, straight cutting can be accomplished by
keeping the band saw blade aligned with the side surface of the
motor housing. Any twisting or cocking of the blade will cause the
cut to go offl ine and decrease the life of the blade.
FIG. 8
NOTICE: During cutting, if the band saw becomes locked or jammed
in the workpiece material, release the switch immediately to avoid
damage to the band saw blade and motor.
5. The tool's own weight provides the most effi cient downward cutting
pressure. Added operator pressure slows the blade and reduces
blade life.
6. End pieces, which would be heavy enough to cause injury when
they drop, after cut-off, should be supported. Safety shoes are
strongly recommended. End pieces may be hot and sharp.
7. Whenever possible, hold the saw fi rmly in both hands. If an
application requires only one hand to be placed on the saw, be
sure to keep the second hand clear of the blade area and do not
allow the saw to fall against the clamped or supported material
when the cut is complete.
Tips for Better Cutting
The following recommendations should be used as a guide (refer to
Figure 9). Results may vary with the operator and the particular material
being cut.
• Never twist the band saw blade during cutting operation.
• Never use liquid coolants with portable band saws. Use of liquid
coolants will cause build-up on tires and reduce performance.
• If excessive vibration occurs during the cut, ensure that the material
being cut is is securely clamped down. If vibration continues,
change the band saw blade.
14
Publicidad
