Publicidad
Step 7
Slide the FEET (T and U) into the notches in the SKIRTS (Q and R).
å
Use a hammer to drive a PROPEL NUT (DD) into the holes in
å
the FEET (T and U). Now, turn an ADJUSTABLE GLIDE (CC)
into each PROPEL NUT as shown in the upper diagram.
Fasten the SKIRTS (Q and R) to the BOTTOM (F). Use four
å
BLACK 9/16" WAFER HEAD SCREWS (QQ) through the FEET
and into the BOTTOM as shown in the lower diagram.
T
R
R
BLACK 9/16" WAFER HEAD SCREW
(4 used for the FEET)
www.sauder.com/services
T
R
Q
This hole must be here.
U
F
Q
R
QQ
CC
(4 used)
DD
U
411572
LARGE DOOR ON LEFT
Page 11
Publicidad
