Publicidad
Step 29
Carefully stand your unit upright.
å
Position your unit near its fi nal location.
å
Turn the ADJUSTABLE FEET (JJ) downward until they touch the fl oor.
å
IMPORTANT: The ADJUSTABLE FEET should not extend beyond the bottom edges of the SIDE
å
SKIRTS (R).
Before fastening the DOOR to your unit, be sure the mounting screw is against the stops as
å
shown in the right diagram. If it isn't, loosen the mounting screw to slide it against the stops.
Then tighten the mounting screw.
Fasten the LARGE DOOR (L) to the LARGE END (B) as shown in the lower diagram. Use
å
the screws in the HINGES. You should start each SCREW a few turns before completely
tightening any of them.
Fasten a PULL (X) to the LARGE DOOR (L). Use two BLACK 7/8" MACHINE SCREWS (NN).
å
See the next step for DOOR adjustments.
å
Stop
Mounting
screw
SILVER 7/8" MACHINE SCREW
(2 used for the PULL)
Turn the ADJUSTABLE FEET
downward until it touches the fl oor.
www.sauder.com/services
Hinge
NN
Floor
JJ
R
411572
LARGE DOOR ON RIGHT
L
B
X
Page 33
Publicidad
