Publicidad
Step 23
Slide the FEET (T and U) into the notches in the
å
SKIRTS (Q and R).
Use a hammer to drive a PROPEL NUT (DD) into the holes in
å
the FEET (T and U). Now, turn an ADJUSTABLE GLIDE (CC)
into each PROPEL NUT as shown in the upper diagram.
Fasten the SKIRTS (Q and R) to the BOTTOM (F). Use four
å
BLACK 9/16" WAFER HEAD SCREWS (QQ) through the
FEET and into the BOTTOM as shown in the lower diagram.
www.sauder.com/services
CC
(4 used)
(4 used)
DD
Q
T
This hole must be here.
U
R
F
R
411572
LARGE DOOR ON RIGHT
T
U
R
R
Q
BLACK 9/16" WAFER HEAD SCREW
(4 used for the FEET)
QQ
Page 27
Publicidad
