Publicidad
Idiomas disponibles
Idiomas disponibles
EN
2. Push and hold the start button (2).
3. While you hold the start button, pull the bail switch (1) in
the direction of the handle bar.
4. Release the start button to start the machine.
8.2
STOP THE MACHINE
1. Release the bail switch to stop the machine.
Wait until the blades fully stop before you start the machine
again. Do not quickly turn the machine off and on.
Always disconnect from the power supply after you
complete the work.
8.3
USE THE CORD RETAINER
In the condition that the extension cable disconnects from the
power supply during operation, the machine contains a cord
retainer. The cord retainer hangs from the cord guide bar.
Make a loop of the extension cable around the cord retainer
(13) before we connect the extension cable into the outlet.
To use the cord retainer:
1. Make a tight loop near the cord retainer (13).
2. Push the loop through the bottom hole in the cord
retainer.
3. Move the loop over the retaining clip (14), and pull down
until the cable attaches to the cord retainer.
8.4
EMPTY THE GRASS CATCHER
1. Stop the machine.
2. Disconnect the machine from the power supply.
3. Open the rear discharge door and hold it.
WARNING
WARNING
NOTE
English
4. Hold the grass catcher by its handle and unhook it from
the slots.
5. Close the rear discharge door.
6. Empty the grass catcher.
8.5
OPERATE ON SLOPES
Do not mow on the slopes with incline more than 15°. If
you are not comfortable, do not mow on a slope.
•
Do not go up and down on a slope, mow across the face
of the slope. Be careful when you change the direction on
a slope.
•
Monitor the holes, ruts, rocks, and other hidden objects
that can cause you to fall. Remove all obstacles such as
rocks and tree limbs.
•
Make sure that your footing is stable. If you are out of
balance, release the bail switch immediately.
•
Do not mow near drop-offs, ditches, or embankments.
8.6
OPERATION TIPS
•
Do not try to override the operation of the start button or
bail switch.
•
Do not tilt the machine when you start it.
•
Do not put hands or feet near or below the turning parts.
•
Keep the discharge chute clean.
•
Do not cut wet grass.
•
Higher blade height is necessary for new or thick grass.
•
Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other debris.
9
MAINTENANCE
Disconnect the machine from power supply before
maintenance.
Keep the engine free from grass, leaves or too much grease.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
10
WARNING
WARNING
WARNING
CAUTION
CAUTION
CAUTION
Publicidad
