GreenWorks 2900802 Manual Del Operador página 6

3. Wait for 1 minute and put the battery pack into the charger again.
EN
• If the status LED shows blinks GREEN, the battery pack is good.
• If the status LED stays blinking RED, the battery pack is defective and it is
necessary to replace the battery pack.
For charger: 29492
PROCEDIMIENTO DE CARGA (INDICADOR LED)
BATTERY IS CHARGING
FULLY CHARGED
BATTERY IS TOO WARM
(REMOVE FOR APPROX.
30 MINUTES TO ALLOW TO
COOL)
NO BATTERY PRESENT
DEFECTIVE BATTERY
(REMOVE AND REPLACE
WITH A NEW BATTERY)
Incorrect Defect Note:
1. Put the battery pack into the charger.
•
pack from the charger for 1 minute.
2. Put the battery pack into the charger again.
• If the status LEDs show correct, the battery pack is good.
• If the status LED1 and LED2 stay blinking, remove the battery pack and
disconnect the charger.
3. Wait for 1 minute and put the battery pack into the charger again.
• If the status LEDs show correct, the battery pack is good.
• If the statusLED1 and LED2 stay blinking, the battery pack is defective and it
is necessary to replace the battery pack.
1
2
3
RED
RED
RED
RED
BLINKING
RED
BLINKING
6
OFF
GREEN
BLINKING
GREEN
OFF
GREEN
BLINKING