Side Broom Maintenance - Nilfisk-Advance Condor BR 1100S serie Instrucciones De Uso

A-24 / ENGLISH

SIDE BROOM MAINTENANCE

The side broom(s) move dirt and debris away from walls or curbs and into the path of the main broom. Adjust the side broom so that the bristles are contacting the
fl oor from the 10 O'clock (AA) to the 3 O'clock (BB) area shown in Figure 13 when the broom is down and running.
To adjust the Side Brooms...
1 The side brooms are adjusted simply by pressing and holding either the Side Broom ON (C) or the Side Broom OFF (L) for 2 seconds (indicator will start
fl ashing) and then let go. You then have 3 seconds to adjust the height by repeatedly pressing the button or holding it down. After the 3 seconds the new
position is stored in memory. The brooms will only return to the factory preset if the control board is replaced.
NOTE: The machine should be stored with the Side Brooms in the raised position. The Side Brooms should be replaced when the bristles are worn to a length of
3 inches (7.62 cm) or they become ineffective.
To replace the Side Broom...
1 Raise the Side Broom(s).
2 Remove the large Pin (CC) holding the side broom on and remove the broom.
3 Install the new broom by sliding it UP onto the shaft and re-installing the Pin (CC).
FIGURE 13
A-24 - FORM NO. 56041633 - Condor™ / BR 1100S series