AirPro P2588 Manual De Instalación página 7

Hanging the Fan
REMEMBER to turn off the power. Follow the
steps below to hang your fan properly.
Attach the mounting bracket to the outlet box
1.
with two screws and washers provided with the
outlet box. Make sure the bracket is tight and
secured (Fig. 4).
Lift fan into position by hanging the motor
2.
assembly onto the hook from the ceiling
mounting bracket allowing it to hang freely
(Fig. 5).
3. Secure the safety cable to the building
structure with a wood screw. (wood screw not
supplied) (Fig. 5)
Outlet Box
Mounting Bracket
Figure 4
Safety
cable
Motor
Figure 5
Making the Electrical
Connections
WARNING: To avoid possible electrical shock,
be sure electricity is turned off at the main fuse
box before wiring.
NOTE: This remote control unit is equipped with
16 code combinations to prevent possible
interference from or to other remote units. The
frequency switches on your receiver and
transmitter have been preset at the factory. Please
recheck to make sure the switches on the
transmitter and the receiver are set to the same
position, any combination of settings will operate
the fan as long as the transmitter and receiver are
set to the same position. (Fig. 6)
Step 1. (Fig. 7) Receiver to House Supply Wires
Electrical Connections: Connect the black (hot)
wire from the ceiling to the black wire marked
"AC in L" from the receiver. Connect the white
(neutral) wire from the ceiling to the white wire
marked "AC in N" from the Receiver. Secure the
wire connections with the plastic wire nuts
provided.
4.