Dometic GROUP 9105100007 Instrucciones De Uso página 32

Cleaning and maintenance
➤ Take out the contents of the cooling device.
➤ If necessary, place them in another cooling device to keep them cool.
➤ Switch off the device.
➤ Leave the cover open.
➤ Wipe off the defrosted water.
6.13 Replacing the plug fuse (12/24 V)
➤ Pull the adapter sleeve (fig. 3 4, page 4) off of the plug.
➤ Unscrew the screw (fig. 3 5, page 4) out of the upper half of the housing
(fig. 3 6, page 4).
➤ Carefully raise the upper half of the housing from the lower (fig. 3 1,
page 4) half.
➤ Take out the contact pin (fig. 3 3, page 4).
➤ Replace the defective fuse (fig. 3 2, page 4) with a new one that has the
same rating (T8A 32V).
➤ Re-assemble the plug in the reverse order.
7 Cleaning and maintenance
WARNING!
!
Always disconnect the device from the mains before you clean and
service it.
NOTICE! Risk of damage
A
 Never clean the cooler under running water or in dish water.
 Do not use abrasive cleaning agents or hard objects during
cleaning as these can damage the cooler.
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any
dust and dirt, so that heat can be released and the device is not damaged.
32
BordBar CDF-11
EN