Descargar Imprimir esta página

Porter Cable PCCW201 Manual De Instrucciones página 10

Ocultar thumbs Ver también para PCCW201:

Publicidad

Idiomas disponibles

Idiomas disponibles

English
THIS PRODUCT USES THE BATTERY
AND CHARGER LISTED IN THE
CHART BELOW.
Description
20V Max* lithium-ion
Battery
20V Max* lithium-ion
Battery Charger
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Attaching hook and loop sanding sheets
(Fig. B)
For best results, use PORTER-CABLE accessories.
To attach the sanding sheet
 10 
over the sanding pad
 5 
ensuring the holes in the disc align
with the holes in the pad and press the sheet firmly in place.
The hook and loop fastening system sanding sheet
can be easily removed by simply pulling it off. It can be
reused as desired.
Fig. B
10
5
Sanding Sheet Tips (Fig. C)
Detach the two additional diamond-shaped tips
from the sanding sheet
 10 
.
note: The diamond-shaped tip
 11 
replaced when worn.
When the front part of the tip
 11 
the sheet, reverse it and press it onto the diamond-shaped
pad tip
 again.
 13 
8
All manuals and user guides at all-guides.com
nOTE: For optimal dust collection, ensure the correct type
of sanding paper is used.
Catalog number
Fig. C
ʵ PCC680L
ʵ PCC681L
ʵ PCC682
ʵ PCC682L
ʵ PCC685L
ʵ
PCC690L
ʵ PCC691L
ʵ PCC692
ʵ PCC692L
ʵ PCC695L
ʵ PCC699L
ʵ PCCB122
Replacing diamond shaped pad tip (Fig. D)
1. Remove the screw
2. Rotate tip to unused side and tighten screw
Finger Attachment
(Fig. D - Optional accessory)
The finger attachment is used for fine detail sanding.
1. Remove the screw
2. Remove the diamond-shaped pad tip
3. Fit the finger attachment
, carefully center the sheet
4. Fit and tighten the screw.
5. Align the appropriate sanding sheet with the
Fig. D
OPERATION

 11 
can be reversed and
is worn, detach it from
When the whole tip is worn, remove it from the sanding
base and fit a new tip.
13
and remove the diamond-
 14 
shaped pad tip
.
 13 
.
 14 
 6 
onto the sanding base as
shown in Figure D.
finger attachment.
14
6
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
11
10
 14 
.
 13 
from the base.
13

Publicidad

loading