Transport And Storage; Manufacturer's Warranty - Hilti SF BT 22­A Manual De Instrucciones Original

7 Transport and storage

WARNING
Fire hazard. Risk of short circuiting.
▶ Never store or transport Li­ion batteries in loose, bulk form.
▶ Remove the battery before transporting or storing the drill.
▶ Observe the nationally and internationally applicable transport regulations when shipping batteries by
road, rail, sea or air.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
The battery doesn't engage
with an audible double click.
The control switch can't be
pressed, i.e. the switch is
locked.
The power tool doesn't run.
The tool doesn't work and
one LED blinks.
The tool cuts out while op-
erating, the 4 LEDs on the
battery display blink.
The battery runs down more
quickly than usual.
The tool or battery gets very
hot.

9 Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Printed: 19.10.2016 | Doc-Nr: PUB / 5310861 / 000 / 00
Possible cause
The retaining lugs on the battery
are dirty.
The safety lock is engaged.
The battery is not fully inserted.
Low battery.
The overload cut-out has been
activated.
The overheating cut-out has been
activated.
Very low ambient temperature.
The tool is overloaded (application
limits exceeded).
Action to be taken
▶ Clean the retaining lugs and
push the battery in until it
engages. Contact Hilti Service
if the problem persists.
▶ Push the switch safety lock to
the side (to the left as seen from
the working direction).
▶ Push the battery in until it
engages with an audible click.
▶ Change the battery and charge
the empty battery.
▶ Release the control switch and
then press it again.
▶ Allow the power tool to cool
down. Clean the air vents.
▶ Allow the battery to warm up
slowly to room temperature.
▶ Pay attention to the power
and performance rating of the
product before using it, i.e
check its suitability for the job
on hand. See "Technical data"
section.
English 7