Switching Off; Care And Maintenance - Hilti SF BT 22­A Manual De Instrucciones Original

5.3 Fitting the belt hook (optional)
WARNING
Risk of injury! Hazard presented by a falling power tool.
▶ A falling power tool may present a risk of injury to yourself and others. Check that the belt hook is
fitted securely before beginning work.
Note
The belt hook allows the drill to be attached to a belt worn by the operator. The belt hook can be fitted
to allow attachment on the left or right side of the body.
▶ Fit the belt hook on the appropriate side of the drill.
5.4 Fitting or removing accessory tools
CAUTION
Risk of injury. The drill may start inadvertently.
▶ Make sure that the safety lock has been activated or that the battery has been removed from the
drill.
1. Open the keyless chuck.
2. Check that the connection end of the accessory tool is clean and then insert it in the keyless chuck or,
respectively, pull the accessory tool out of the keyless chuck.
3. Retighten the keyless chuck.
5.5 Switching on
▶ Press the control switch.
Note
The running speed can be controlled smoothly right up to maximum speed by varying how far the
control switch is pressed in.

5.6 Switching off

▶ Release the control switch.

6 Care and maintenance

WARNING
Electrical hazards. Improper repairs to electrical parts may lead to serious injuries.
▶ Electrical parts may be repaired only by trained electrical specialists.
Note
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Center or online at: www.hilti.com
▶ Keep the tool, especially its grip surfaces, clean and free from oil and grease.
▶ Do not use cleaning agents containing silicone.
▶ Never operate the power tool when the ventilation slots are blocked. Clean the air vents carefully using a
dry brush. Do not permit foreign objects to enter the interior of the tool.
▶ Clean the outside of the tool at regular intervals with a slightly damp cloth. Do not use a spray, steam
pressure cleaning equipment or running water for cleaning. This may negatively affect the electrical
safety of the power tool.
6 English
Printed: 19.10.2016 | Doc-Nr: PUB / 5310861 / 000 / 00
5
6