Publicidad
F7
F8
F9
F10
F11
28
English
8. Operating the engine
WARNING
It is very dangerous to run a chainsaw that mounts
broken parts or lacks any parts.
Before starting engine, make sure that all the parts
including bar and chain are installed properly.
STARTING THE ENGINE
1. Fill fuel and chain oil tanks respectively, and tighten
the caps securely. (F7)
2. Set the switch to "I" position. (F8)
(1) Chain oil
(2) Fuel
(3) Switch
3. While holding the throttle lever together with the
trigger safety, push in the side latch and release the
throttle lever to leave it at the starting position. (F9)
(1) Trigger safety
(2) Throttle lever
(3) Latch
4. Pull out the choke knob to the closed position. (F10)
(1) Choke knob
NOTE
When restarting immediately after stopping the engine,
set the Choke knob in the first-stage position (choke
open and throttle lever in the starting position).
5. While holding the saw unit securely on the ground,
pull the starter rope vigorously. (F11)
WARNING
Do not start the engine while the chain saw hangs
in one hand. The saw chain may touch your body.
This in very dangerous.
Publicidad
