Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning the shaver
Do not use kitchen, bathroom, or toilet detergents. Also, do not
wipe with thinners, benzine, alcohol etc.
Doing so may result in malfunction.
1. Turn the power switch OFF, and disconnect the AC adaptor.
• Unlock the switch lock.
2. Apply some hand soap and some water to the system outer foil.
3. Press the power switch for more than
2 seconds to activate the sonic vibration
cleaning mode.
• The battery capacity lamps blink in order.
• After about 20 seconds, it will be
automatically turned off.
4. Remove the outer foil section and press
the power switch for more than
2 seconds to activate the sonic vibration
cleaning mode.
5. Clean the shaver, the outer foil section,
and the trimmer with running water.
• After rinsing with water, shake the
shaver up and down for a few times to
remove excess moisture.
Hitting the vanity, etc., while shaking
the shaver may cause malfunction.
• Splashing is reduced by rinsing the shaver in sonic vibration
cleaning mode.
6. Wipe off any drops of water with a dry cloth.
14
ES-LT5N_3N_US.indb
14
7. Dry the outer foil section, the shaver, and
the trimmer completely.
8. Attach the outer foil section to the shaver.
Replacing the system outer foil and the inner blades
system outer foil
once every year
inner blades
once every two years
►Removing the outer foil section
Press the foil frame release buttons and lift the
outer foil section upwards.
►Attaching the outer foil section
After turning the foil frame mark (
securely attach the outer foil section to the shaver
until it clicks.
) to the front,
2015/04/17
17:38:34
Publicidad
