Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Possible cause
The jar is not placed
on the main unit
correctly.
You have started a
second steaming
cycle immediately
after the previous
one has finished.
The control knob has
not been turned to
the off position (OFF)
after the previous
steaming cycle was
finished.
The water tank
You have not pre-
gives off an
washed the water
unpleasant smell
tank before use.
during the first few
times of use.
The appliance
You have not put
does not generate
water in the water
steam.
tank.
There is too much
limescale buildup in
the water tank.
Steam is leaking
The water tank lid is
from the water
not closed correctly.
tank.
The jar is not
assembled correctly
on the main unit.
The steam outlet
on the water tank
lid is blocked by
contamination or
limescale buildup.
The steam inlet on
the jar lid is blocked
by contamination.
The ingredients
The pieces in the jar
are not
are too big.
completely
heated through.
Solution
Place the jar on the main unit correctly
with the jar lid on the bottom.
Switch off the appliance and allow it to
cool down for 10 minutes before you
start a second steaming cycle.
Turn the control knob to the off position
(OFF) first, and then turn it again to
choose the operating time.
Refer to the chapter "Cleaning and
descaling" to clean the water tank, and
then finish a steaming cycle with an
empty jar.
Switch off and unplug the appliance,
and then add water to the water tank.
Descale the water tank. Refer to the
section "Descaling" in the chapter
"Cleaning and descaling".
Close the water tank lid correctly. Make
sure the
icon on the water tank lid is
lined up with the
icon on the water
tank.
Place the jar correctly on the main unit.
Clean the steam outlet on the water tank
lid.
Clean the steam inlet on the jar lid.
Cut the food into smaller pieces (cubes
no bigger than 1 cm).
ENGLISH
23
Publicidad
