Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
V-belts
Check at 100 hour intervals of operation. Check
for severe cracking and large nicks.
NOTE: The belt will show some small cracks in
usual operation.
The belts are not adjustable. Replace belts if they
begin to slip from wear.
Deck Belt Removal
1. Park on a level surface. Engage park brake.
2. Lower the deck into the lowest cutting
position.
3. Remove the bolts from the belt shields and
remove the shields.
4. Remove dirt or grass from around the cutter
housings and the deck surface.
5. Loosen the nut securing the belt guide. Pull
the belt guide up out of the idler arm.
6. Push inward on the idler arm to release the
tension on the belt.
7. Carefully lift the belt over the top of the cutter
housing pulleys and remove belt from the
deck.
Deck Belt Installation
NOTE: For ease in installing the deck belt, refer to
the routing decal on the top of the deck.
1. Wind the deck belt around the electric clutch
pulley located on the engine shaft.
2. Route the belt forward and up onto the deck.
3. Position the belt around spring loaded idler
pulley.
4. Wind the belt around the stationary idler pulley
and the mandrel housings.
5. Push inward on the idler arm and carefully put
the belt over the stationary idler pulley. When
the belt is correctly routed, slowly release the
idler arm to tension the belt.
6. Double check the belt routing to make sure it
matches the routing decal, and the belt does
not have twists.
24
7. Set the loosened belt guide into the idler arm
hole and tighten the pulley bolt.
8. Replace belt shields on both mandrel
housings and secure with fasteners.
Adjusting the Mower Deck
Leveling deck
Adjust the deck while the mower is on a level
surface. Make sure the tires are inflated to
the correct pressure. See Technical Data /
Transmission. If tires are under or over inflated,
the deck cannot be correctly adjusted. Raise the
deck to the highest (transport) position.
The deck must be adjusted slightly higher in the
rear.
NOTE: To insure the precision of the leveling
procedure, the mower deck drive belt must be
installed before leveling the deck.
1. Wear heavy gloves. Turn each outer blade tip
to align front to rear with the deck side-to-side.
2. Measure from the floor surface up to the
bottom of the blade tip on the discharge side
of the mower deck. Record the measurement.
3. Move to the opposite side, check that
measurement is the same. If adjustment is
required—with a 3/4" or adjustable wrench,
turn the lift link adjustment nuts on either
side counter clockwise to lower or clockwise
to raise. Adjust until both measurements are
equal.
4. Turn either blade to align with the deck front-
to-rear. If the front blade tip does not measure
1/4" to 3/8" (6,35 mm to 9,52 mm) lower
Publicidad
