Publicidad
Idiomas disponibles
Idiomas disponibles
1. Place log #1 onto rear grate bracket (see
Figure 23).
2. Place log #2 and log #3 onto middle grate
bracket (see Figure 24).
3. Place log #4 and log #5 onto front grate
bracket (see Figure 25).
4. Place logs #6, #7, #8 and #9 as shown in
Figure 26.
Log #1
Figure 23 - Installing Log #1
Log #2
Figure 24 - Installing Logs #2 and #3
CAUTION: Do not mix old and
new batteries. Do not mix alka-
line, standard (carbon - zinc), or
rechargeable (nickel - cadmium)
batteries. Do not dispose of
batteries in fire, batteries may
explode or leak.
• Batteries are included.
• Remove batteries when depleted.
• Install/replace the batteries according to the
type and quantity stated in table to the right.
• Do not mix old and new batteries. New bat-
teries should be the same brand for best
results.
200133-01A
INSTALLATION
Model CRHD24T (24" Log Set)
Log #3
Battery Instructions
www.usaprocom.com
IMPORTANT: Make sure logs do not cover
any burner ports. It is very important to install
the logs exactly as instructed. Do not modify
logs. Use only logs supplied with heater.
Log #4
Figure 25 - Installing Logs #4 and #5
Log #6
Figure 26 - Installing Logs #6, #7, #8 & #9
• Be sure to observe proper polarity (+/-)
when installing or replacing the batteries.
Damage due to improper battery installation
may void the warranty on the product.
• For long periods of non-operation, remove
batteries from all components for safety.
AAA
Battery
Positive
UP
Figure 27 - Installing Battery in Ignitor
Log #5
Log #8
Log #9
Log #7
19
Publicidad
