Publicidad
Idiomas disponibles
Idiomas disponibles
•
It is recommended ironing clothes that require low temperatures first and then medium and high
temperatures. This operation allows to save time since the ironing plate heats faster than it cools down.
•
When you do not know the composition, it is recommended to iron a non-visible part of the it, starting
from the lowest temperature to find the most suitable temperature.
•
Sometimes the clothing becomes shiny, in this case you need to iron it on the inside not to ruin it. When
ironing at maximum temperature (MAX), it is recommended to place a cloth between the ironing plate
and the fabric.
Setting the temperature
1)
Place the iron vertically. Plug the device to the electrical outlet.
2)
Select the temperature regulator (10) according to the symbols shown on the previous page. The chosen
symbol has to be aligned with the mark placed on the tank. The iron plate temperature control light
shows that iron plate (8) is warming up. Wait until light turns off to start ironing.
Caution: While ironing, the control light lights up periodically indicating that the temperature is constant. If
you lower the thermostat, do not start ironing until the iron temperature control light turns off.
STEAM IRONING
Before using the steam check that the water contained in the tank is enough. Adjust steam power using the
control knob (3). Place the steam control knob between minimum and maximum depending on the amount of
steam required and temperature.
Caution: the iron provides continuous steam only if it is held in a horizontal position and if the plate is hot. It
is possible to stop the continuous jet of steam by placing the iron vertically or placing the steam control (3) to
"0". To avoid the dripping of water, it is recommended to only use steam at high temperatures.
STEAM JET – WATER SPRAY
Steam jet
: press the steam-shot button (4) for having a vigorous jet of steam which can penetrate the fibers
and soften even the most stubborn creases. Wait a few seconds before pressing.
By pressing the button periodically is also possible to freshen up curtains, hanging clothes, etc ...
Caution: the steam shot function can only be used at high temperatures; stop the jet when the temperature
control light lights up, start again when it goes out.
Water spray
: press the water spray button (5) slowly for having dense spray; press fast for vaporized spray.
Caution: make sure there is water in the tank. For delicate fibers it is advisable to moisten the article before
using the spray. To prevent stains, do not use the spray over silk and synthetic fibers.
DRY IRONING
To perform dry ironing, move the steam regulator (3) in "0" position. In this position, the steam emission is
disable, otherwise the water spray option is still unable.
LABEL
FABRIC
Synthetic
(Acrylic, nylon...)
silk – wool
cotton – linen
TEMPERATURE
·
Low temperature
··
Medium temperature
···
High temperature
Do not iron
13
Publicidad
