Publicidad
Idiomas disponibles
Idiomas disponibles
90550099 PC1800DS Crdl Sander REVISED
Symbols
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V..................volts
Hz................hertz
min ..............minutes
............direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
sfpm ............surface feet per minute
SAVE THESE INSTRUCTIONS
This product can accept any of the batteries and chargers listed in the chart below.
LI-ION Battery Packs and Chargers
Description
Battery:
LI-ION 18V
Charger: LI-ION
FUNCTIONAL DESCRIPTION
1. On/Off Switch
2. Sanding Base
3. Vacuum Port
4. Battery Compartment
5. Finger Attachment
6. Vacuum Port Adaptor
IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CHARGERS
SAVE THESE INSTRUCTIONS: This manual contains important safety instructions for
battery chargers.
• Before using charger, read all instructions and cautionary markings on charger, battery
pack, and product using battery pack.
:
Shock hazard. Do not allow any liquid to get inside charger.
:
Burn hazard. To reduce the risk of injury, charge only designated
PORTER-CABLE batteries. Other types of batteries may burst causing personal injury
and damage.
:
Under certain conditions, with the charger plugged in to the power
4/1/09
1:52 PM
A ..................amperes
W..................watts
................alternating current
n o ................no load speed
..................earthing terminal
................safety alert symbol
.../min or rpm...revolutions or
NI-CD Battery Packs and Chargers
Cat. #
Description
PC18BL
Battery: NI-CD 18V
PC18BLX
Charger: NI-CD
PC18BLEX
PCLMVC
PCXMVC
A
4
5
Page 5
reciprocation per minute
Cat. #
PC18B
PCMVC
PCXMVC
1
5
2
3
6
Publicidad
