Cutting - Oregon PS250 Manual De Instrucciones Original

OREGON® Cordless Tool System
POLE SAW MODEL PS250
• Turn the extension collar counter
clock-wise (1) until the shaft slides
freely (Fig 28)
• Slide the shaft until it is the desired
length (2)
FiG. 28
(2)
(1)
• Turn the extension collar clockwise to
lock the shaft in place
STOPPING ThE POLE SAW
Release the trigger switch to stop the
pole saw
STARTING ThE POLE SAW
WARNING: TO REDUCE ThE RISK
OF INJURY, NEVER DEFEAT ThE
INTERLOCK BY TAPING, WIRING, OR
TYING DOWN ThE TRIGGER LOCK-
OUT.
If using the harness, put on the harness
and attach the harness clip to the
attachment ring Grasp the extendable
shaft and the rear handle firmly (Fig 29)
Squeeze the trigger lock-out (1) with the
palm of the hand, and the trigger switch
(2) with the fingers
FiG. 29
(1) TriGGEr LOCK-OuT
(2) TriGGEr SWiTCH
AC 1113 - F/N 563397
OPErATiNG THE POLE SAW

CUTTING

BASIC CUTTING
DANGER: TO REDUCE ThE RISK OF
ShOCK, NEVER OPERATE ThIS TOOL
NEAR ANY WIRES OR CABLES WhICh
MAY BE CARRYING ELECTRIC
CURRENT.
ELECTRICITY CAN ARC FROM ONE
POINT TO ANOThER. MAINTAIN A
DISTANCE OF AT LEAST 50 FT (15 M)
BETWEEN ThE POLE SAW AND ANY
ELECTRICAL LINE CARRYING LIVE
CURRENT OR BRANCh CONTACTING
AN ELECTRICAL LINE. BEFORE
WORKING CLOSER ThAN 50 FT (15 M),
CONTACT ELECTRIC UTILITY AND
MAKE SURE ThE CURRENT IS TURNED
OFF (FIG. 30).
FiG. 30
50 FT
(15 M)
21