Publicidad
Idiomas disponibles
Idiomas disponibles
2610056809 GSR GSB18V-975C 03-21.qxp_GSB18V-975C 3/5/21 4:34 PM Page 15
Inserting and Releasing
Battery Pack
Set Forward/Reversing lever to the center (off
position). Slide charged battery pack into the
housing until the battery pack locks into position
(Fig. 11). To check if the battery is locked in
place, lightly pull the battery in the opposite
direction. If the battery moves, do not use the
tool and repeat the insertion procedure until the
battery is locked in place and does not slide
backwards.
Your tool is equipped with a secondary locking
latch to prevent the battery pack from
completely falling out of the handle, should it
become loose due to vibration.
To remove the battery pack, press the battery
pack release button and slide the battery pack
towards the front of the tool. (Fig. 12).
Press the battery pack release button again and
slide the battery pack completely out of tool
housing (Fig. 12).
Depth Gauge
Your drilling depth can be pre-set and/or
repeated by using the depth gauge.
Setting depth: After the auxiliary handle is
installed, make sure the drill bit has been fully
inserted into the chuck before setting the
depth gauge.
To adjust depth, turn the wing nut counter-
clockwise to loosen depth gauge, slide depth
gauge to desired depth X and securely tighten
wing nut clockwise (Fig. 13).
Operating Instructions
FIG. 12
DEPTH
G UGE
SAVE THESE INSTRUCTIONS
BATTERY
PACK
BATTERY
PACK
RELEASE
BUTTON
X
DRILL BIT
FIG. 11
FIG. 13
WING
NUT
15
Publicidad
