Publicidad
Idiomas disponibles
Idiomas disponibles
2610056809 GSR GSB18V-975C 03-21.qxp_GSB18V-975C 3/5/21 4:34 PM Page 16
Temperature Overload
Protection
Avoid
using
battery
continuously, for long periods of time, while
subjecting the tool to overload conditions,
such as drilling with large diameter accessories
into hard materials. Using battery powered
tools at extreme loads, may cause the battery
to exceed its allowable operating temperature
range. When the battery exceeds normal
operating temperature caused by overload, the
speed of the tool may be reduced and the tool
may appear to lose power. To regain the tool's
full performance, the battery must be allowed
to cool, until the operating temperature returns
to normal.
KickBack Control
(Rapid Shut-off)
To ensure better control of the tool
during operation, this tool is design to
shut-off while in use if a sudden or
unexpected bind up situation occurs.
Bind up occurs when the bit gets jammed during
operation, which forces the bit to stop spinning
abruptly. If this occurs, the tool will shut down
and the KickBack Control will be indicated by
flashing LED lights on the tool.
The sensitivity level of this feature is adjustable.
Using Bosch Toolbox app on a mobile device,
operator may select one of three settings
between "Earlier" and "Later" markers on the
To reduce the risk of injury read the operating instructions included with Bosch
GCY42 connectivity module. Operating instructions for GCY42 connectivity
module include important information not covered in this manual.
Bluetooth®
Do not use the power tool
with Bluetooth® in the
vicinity of gas stations, chemical plants, areas
where there is danger of explosion and areas
subject to blasting. Do not use the power tool
with Bluetooth® in airplanes. Do not use the
power tool with Bluetooth® in the vicinity of
medical devices. Avoid operation in the direct
vicinity of the human body over longer periods
16
Operating Instructions
app. The settings only control the KickBack
Control activation delay, and do not change the
capacity of this feature.
operated
tools
When the switch trigger is pressed, operator is
notified about the KickBack Control settings, by
the work light and function red light identified in
Fig. 1 on page 8.
The setting indications are as follows:
R
R R R R
W W W W
The label next to the work light displays the Kick
Back setting indicator light pattern.
This feature can only be activated when the tool
is running at maximum speed.
NOTE: The default KickBack Control setting for
the tool is "Later". KickBack Control setting for
the tool without GCY42 module installed is
always set to default.
Connectivity
of time. When using the power tool with
Bluetooth®, interference with other devices and
systems, airplanes and medical devices (e.g.,
cardiac pacemakers, hearing aids) may occur.
The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth SIG,
Inc. and any use of such marks by Robert Bosch
Tool Corporation is under license.
SAVE THESE INSTRUCTIONS
Continuous white light (W) = Later
W
(delayed Kick Back activation).
Slow alternating red (R) and white (W)
W
R
W
light = Mid-Level (less delayed activation).
Fast alternating red (R) / white (W) light =
Earlier (minimum delay to activation).
RED LIGHT WHITE LIGHT
Follow all instructions and
warnings provided by your
Publicidad
