Delta ShopMaster SM400 Manual De Instrucciones página 14

ADJUSTING LOWER BLADE
GUIDES AND BLADE
SUPPORT BEARING
The lower blade guides and blade support bearing
should be adjusted at the same time as the upper guides
and support bearings as follows:
DISCONNECT MACHINE FROM POWER
SOURCE.
1. Loosen two screws (A) Fig. 24, and move guides (B)
as close as possible to the sides of the blade, being
careful not to pinch the blade. Then tighten the two
screws (A).
2. The front edge of guide blocks (B) Fig. 24, should be
adjusted so they are just behind the "gullets" of the blade
teeth by loosening screw (C), and moving assembly (D)
in or out as necessary. Then tighten screw (C).
3. The lower blade support bearing (E) Fig. 24, should
be adjusted to support the rear of the blade during the
cutting operation and also prevent the blade from being
pushed too far to the rear which could damage the blade.
The support bearing (E) Fig. 24, should be set about
1/32" behind the blade by loosening screw (F) Fig. 24,
and moving shaft (G) in or out. Then tighten screw (F).
4. The lower blade support bearing (E) Fig. 24, should
also be adjusted so the back of the blade overlaps the
outside diameter of the ball bearing by approximately
1/8". The blade support bearing (E) is set on an eccentric
shaft.To change position of bearing (E), loosen screw (F)
Fig. 24, and rotate shaft (G) Figs. 24 and 25, until the
blade properly overlaps the support bearing. Then
tighten screw (F) Fig.24.
TILTING THE TABLE
The table can be tilted 45 degrees to the right. To tilt the
table, loosen lock handle (A) Fig. 26, and turn knob (B)
clockwise until desired angle is established. Then tighten
lock handle (A). NOTE: The table lock handle (A) can be
repositioned by pulling out on the handle and
repositioning it on the nut located underneath the hub of
the handle. A scale (C) and pointer (D) are provided to
indicate the degree of tilt.
G
A
14
E
F
D
C
B
A
Fig. 24
G
Fig. 25
E
A
B
D
C
Fig. 26