Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting the Battery Cables
CALIFORNIA PROPOSITION 65 WARNING
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals known
to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
CAUTION:
connect the POSITIVE (red) wire to its terminal first,
followed by the NEGATIVE (black) wire.
To connect the battery cables, proceed as follows:
NOTE: The positive battery terminal is marked Pos. (+). The
negative battery terminal is marked Neg. (–).
1.
Remove the plastic cover, if present, from the positive (+)
battery terminal and attach the red cable to the positive (+)
battery terminal with the bolt and hex nut. See Fig. 3-3.
2.
Remove the plastic cover, if present, from the negative (–)
battery terminal and attach the black cable to the negative
(–) battery terminal with the bolt and hex nut. See Fig. 3-3.
3.
Position the red rubber boot over the positive battery
terminal to help protect it from corrosion.
NOTE: If the battery is put into service after the date shown
on top/side of battery, charge the battery as instructed in the
Maintenance & Adjustments section your Operator's Manual
prior to operating the tractor.
10
s
2 — a
ectiOn
sseMbly
When attaching battery cables, always
Figure 3-3
& s
-u
et
p
Checking Tire Pressure
WARNING!
:
of tires for maximum psi. Equal tire pressure should
be maintained at all times.
The tires on your tractor may be over inflated for shipping
purposes. Reduce the tire pressure before operating the tractor.
Check sidewall of tires for maximum psi.
Setting the Deck Gauge Wheels
Move the tractor on a firm and level surface, preferably
pavement, and proceed as follows:
1.
Select the height position of the cutting deck by placing
the deck lift lever in the normally desired mowing height
setting (any of the six different cutting height notches on
the right fender).
2.
Check the gauge wheels for contact or excessive clearance
with the surface below. The deck gauge wheels should
have between ¼" and ½" clearance above the ground.
If the gauge wheels have excessive clearance or contact with the
surface, adjust as follows:
a.
Raise the deck lift handle to its highest setting.
b.
Remove the front and rear gauge wheels by
removing the lock nuts and shoulder screws which
secure them to the deck. See Fig. 3-4.
c.
Place the deck lift lever in the desired mowing
height setting.
d.
Reinsert the shoulder screw (with each gauge
wheel) into the index hole that leaves approximately
½" between the bottom of the wheel and the
pavement.
Refer to Leveling the Deck in the Maintenance section of this
manual for more detailed instructions regarding various deck
adjustments.
Do not overinflate tires. Check sidewall
Figure 3-4
Publicidad
