Publicidad
Idiomas disponibles
Idiomas disponibles
Table of Contents
Table of Contents ......................................2
Safety Information ....................................2
Precautions ............................................2
Warranty ...................................................2
2-Year Warranty .....................................2
Specifications ...........................................3
Pre-Installation .........................................3
Planning Installation ..............................3
Safety Information
PRECAUTIONS
Please read and understand this entire manual before
attempting to assemble, install, or operate this light
fixture.
This light fixture requires 120-volts AC.
Some codes require installation by a qualified electrician.
This light fixture must be properly grounded.
This light fixture is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
For proper operation, this light fixture should be:
Installed outdoors to a wall or eaves
Installed 8 ft. (2.4 m) above the ground (If the light
fixture is mounted higher than recommended,
aiming the sensor down will reduce the coverage
area.)
Do not leave the "ON-TIME" switch in the "TEST"
position. The frequent ON/OFF cycling of the light
fixture will reduce the life of the bulb
Warranty
2-YEAR WARRANTY
Contact the Customer Service Team at 1-866-308-3976 or visit www.homedepot.com.
Tools Required .......................................3
Hardware Included .................................4
Package Contents ..................................5
Mounting Locations ...............................5
Installation ................................................6
Operation...................................................7
Care and Cleaning ..................................10
Troubleshooting ......................................10
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
WARNING: Risk of fire. Do not aim the bulbs at a
combustible surface within 3 ft. (1 m).
WARNING: Risk of fire. Keep the bulbs at least 2 in.
(51 mm) from combustible materials.
CAUTION: Keep the motion sensor at least 1 in. (25 mm)
away from the bulbs.
CAUTION: Keep the bulb holders 30° below horizontal to
avoid water damage and electrical shock.
CAUTION: To avoid water damage and the risk of
electrical shock, the motion sensor controls must be facing
the ground when the installation is complete.
CAUTION: Burn hazard. Allow the light fixture and the
bulb to cool before touching.
CAUTION: Do not cut any wires with factory installed
wire connectors or remove the wire connectors.
NOTICE: Do not connect this light fixture to a dimmer switch or
timer.
2
Publicidad
