Publicidad
Idiomas disponibles
Idiomas disponibles
Pre-Installation (continued)
PACKAGE CONTENTS
Part
Description
A
Bulb holder
B
Canopy
C
Motion sensor
D
Shell
MOUNTING LOCATIONS
Determine the mounting location – a wall or under
an eave.
Position bulb holders (A) in the general direction
of the desired light coverage and tighten the lock
nuts (1) and the thumb screws (2).
If needed, lift the motion sensor (C) up and
rotate it so the controls face the ground after
installation. Tighten the clamp screw (3) when
done. Do not overtighten.
NOTE: If the motion sensor (C) pops out of the ball joint,
loosen the clamp screw (3), push the motion sensor (C)
back into the ball joint, and tighten the clamp screw (3). Do
not overtighten.
A
D
C
B
A
Quantity
Wall Mount
A
2
2
1
1
C
3
5
Please contact 1-866-308-3976 for further assistance.
D
2
1
1
2
Eave Mount
HOMEDEPOT.com
Publicidad
