LG LSSE3030 Serie Manual Del Propietário página 56

56 TROUBLESHOOTING
Symptoms
Oven door does not
open after a Self
Clean cycle
The oven does not
clean after a Self
Clean cycle
CLEAN and door flash
in the display
LOCKED is on in the
display when you
want to cook
Burning or oily odor
emitting from the vent
Oven racks are
difficult to slide
Moisture collects on
oven window or steam
comes from oven vent
A chime sounds when
surface elements are
turned on.
Trouble connecting
appliance and
smartphone to Wi-Fi
network
Possible Causes / Solutions
• Oven is too hot.
- Allow the oven to cool below locking temperature.
• Allow about one hour for the oven to cool after the completion of a Self Clean
cycle. The door can be opened when the lock
• The control and door may be locked.
• Oven controls not properly set.
- See the Self Clean section.
• Oven was heavily soiled.
- Clean up heavy spillovers before starting the clean cycle. Heavily soiled ovens
may need to Self Clean again or for a longer period of time.
• The Self Clean cycle has been selected, but the door is not closed.
- Close the oven door.
• The oven door is locked because the temperature inside the oven has not
dropped below the locking temperature.
- Turn the oven mode knob to the Off position. Allow the oven to cool.
• This is normal in a new oven and will disappear in time.
- To speed the process, set a Self Clean cycle for a minimum of 3 hours. See
the Self Clean section.
• The shiny, silver-colored racks were cleaned in a Self Clean cycle.
- Apply a small amount of vegetable oil to a paper towel and wipe the edges of
the oven racks with the paper towel.
• This is normal when cooking foods high in moisture.
• Excessive moisture was used when cleaning the window.
• When any cooktop burner is activated, a chime sounds to indicate the cooktop is
in use.
• The password for the Wi-Fi network was entered incorrectly.
- Delete your home Wi-Fi network and begin the registration process again.
• Mobile data for your smartphone is turned on.
- Turn off the Mobile data on your smartphone before registering the appliance.
• The wireless network name (SSID) is set incorrectly.
- The wireless network name (SSID) should be a combination of English letters
and numbers. (Do not use special characters.)
• The router frequency is not 2.4 GHz.
- Only a 2.4 GHz router frequency is supported. Set the wireless router to 2.4
GHz and connect the appliance to the wireless router. To check the router
frequency, check with your Internet service provider or the router manufacturer.
• The distance between the appliance and the router is too far.
- If the appliance is too far from the router, the signal may be weak and the
connection may not be configured correctly. Move the router closer to the
appliance or purchase and install a Wi-Fi repeater.
is no longer displayed.