Publicidad
Idiomas disponibles
Idiomas disponibles
BLADE CARE
For best results mower blades must be kept sharp. Re place
bent or damaged blades.
CAUTION: Use only a replacement blade ap-
proved by the manufacturer of your tractor.
Using a blade not approved by the manu-
facturer of your tractor is hazardous, could
damage your tractor, and void your warranty.
BLADE REPLACEMENT (See Figs. 28 - 33)
•
Raise mower to highest position to allow access to
blades.
CAUTION: When handling the blade, protect your hands
with gloves and/or wrap blade with heavy cloth.
TO REMOVE BLADE
•
Squeeze tabs inward to release cap. Remove by lifting
cap from hinge and set aside. (See Fig. 28.)
TABS
Fig. 28
•
Slide thumb lock and release pivot to allow wire-form
to swing free from standoffs. (See Fig. 29.)
PIVOT
WIRE-FORM
STANDOFFS
Fig. 29
•
Open the top plate and remove blade. (See Fig. 30.)
NOTE: Blade is held in place by magnets to prevent free
release.
BLADE
Fig. 30
All manuals and user guides at all-guides.com
MAINTENANCE
CAP
HINGE
THUMB LOCK
TOP PLATE
TO INSTALL BLADE
•
Clean area under top plate, the bottom of the mandrel
assembly, and around bosses thoroughly to remove
any dirt or debris.
•
Align bosses and insert blade. (See Fig. 31.)
NOTE: Magnets should hold blade in place.
TOP PLATE
BLADE
•
Close the top plate over the blade and hook the wire-
form over the standoffs.
•
Push pivot closed until secured by the thumb lock. (See
Fig. 32.)
PIVOT
WIRE-FORM
STANDOFFS
•
Reinstall cap. Hook cap onto hinge and rotate onto
tabs. Press cap firmly into place, ensuring both tabs
lock into cap. (See Fig. 33.)
NOTE: Replace cap if worn or cracked.
TABS
20
MANDREL
ASSEMBLY
Fig. 31
THUMB LOCK
Fig. 32
HINGE
CAP
Fig. 33
BOSS
Publicidad
