Descargar Imprimir esta página

EuroLite TS-7 Manual Del Usuario página 21

Ocultar thumbs Ver también para TS-7:

Publicidad

Idiomas disponibles

Idiomas disponibles

MADE IN CHINA
(9) Fuseholder
(10) Power supply
(11) DIP-switches
(12) Control LED
(13) DMX-Out socket
(14) DMX-In socket
INSTALLATION
Installing/Replacing the lamp
The lamp must only be changed when wearing appropriate protective clothing (protection glasses, protection
gloves, helmet with sight, leather apron).
The lamp life given by the manufacturer must never be exceeded. This is why you need to take notes on the
operational time of the lamp or check the operating hour meter (if available) regularly and replace the lamp in
time.
Keep exchanged lamp in a protective container and remove accordingly.
During the operation, the lamp reaches temperatures of up to 600° C.
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 10 minutes).
9
10
Typ/Type/Type/Tipo: EUROLITE TS-7
Spannungsversorgung/Power supply/Aliment.: 230 V AC, 50 Hz ~
Ges. anschl. wert/Power cons./Puiss. de rendement/Cons.: 250 W
Sicherung/Fuse/Fusible/Fusible: F 2.5 A, 250 V
Lampe/Lamp/Lampe/Lámpara: ELC 24 V/250 W
Vor Gebrauch Anleitung lesen. Lire le mode d'emploi avant l'utilisation.
Lea el manual del usuario antes de la puesta en marcha.
F
0.5 m
T =45° C
T =70° C
a
B
®
eurolite
eurolite
www.eurolite.de
LIGHTING CONTROL
PROTOCOL DMX-512
Read user manual before use. Only for professional use! Keep away from moisture! Never
operate the device without protective shield! Never look directly into the light source (especially
meant for epileptics)! Caution: During the operation the housing becomes very hot! Danger to
life! Do not open for 10 minutes after switching off. Isolate luminaire from all poles of the mains
supply before opening the housing or replacing the lamp. Caution - hot lamp. Maintenance and
service operations only by authorized dealers. Replace any cracked protective shield.
DANGER TO LIFE!
Only install the lamp with the device switched off!
Unplug from mains before!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
XLR occupation:
1: Ground
2: Signal (–)
3: Signal (+)
Out
1
3
2
In
2
3
1
CAUTION!
21/53
11
12
13
14
51785814_V_2_0.DOC

Publicidad

loading