Publicidad
Idiomas disponibles
Idiomas disponibles
SIDE BURNER MAINTENANCE
WARNING: All gas controls and supply valves should be in
the "OFF" position.
Make sure black wire is connected between the igniter and electrode.
Make sure white wire is connected between the igniter and grounding clip.
Spark should be a white/blue color, not yellow.
1)
Igniter Wire
2)
Ground wire
3)
Burner
Side Burner Grate
Side Burner cap
Side Burner Ring & Head
Igniter Electrode
PROBLEM
Burners burn with a yellow or orange flame, in
conjunction with the smell of gas (This is normal
for the burner lighting tube).
Symptoms:
Burner does not light, or flame is low in "HI"
position.
Experiencing flare-ups:
CAUTION: Do not line the bottom tray
with aluminum foil.
Burner flame pattern is erratic. Flame is low when
burner is on "HI". Flames do not run the whole
length of the burner tube.
Inside of lid appears to be "peeling." (Resembles
paint peeling.)
Cabinet doors are not aligned.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
®
site. Log onto www.weber.com
.
WWW.WEBER.COM
®
SIDE BURNER MAINTENANCE
Control Knob
Igniter
TROUBLESHOOTING
Inspect Spider/Insect Screens for possible obstructions.
(Blockage of holes.)
Is fuel hose bent or kinked?
Does Burner light with a match?
Did you use the snap igniter several times until the main
burner lit (See Lighting Instructions)?
Does the igniter work (Do you see a spark when you
repeatedly use the snap igniter?
Are you preheating barbecue in the prescribed manner?
Are the cooking grates and Flavorizer
coated with burned-on grease?
Is the bottom tray "dirty" and not allowing grease to flow
into catch pan?
Are burners clean?
The lid is porcelain enamel or stainless steel, not paint. It
cannot "peel". What you are seeing is baked on grease
that has turned to carbon and is flaking off.
THIS IS NOT A DEFECT.
Check the adjustment pin on the bottom of each door.
CHECK
Clean Spider/Insect Screens. (See Section "Annual
Maintenance")
Straighten fuel hose.
If you can light Burner with a match, then check the
Crossover
Make sure to hold the control knob in for two seconds after
snapping the igniter and seeing the orange flame from the
burner lighting tube.
Try manually lighting the burner (refer to "Main Burner
Manual Lighting"). Call customer service.
All burners on HI for 10 to 15 minutes for preheating.
®
bars heavily
Clean thoroughly. (See Section "Cleaning")
Clean bottom tray.
Clean burners. (See Section "Maintenance".)
Clean thoroughly. (See Section "Cleaning".)
Loosen adjustment nut/s. Slide door/s until aligned. Tighten
nut.
29
CURE
®
ignition system.
29
Publicidad
