Black and Decker BDH2000L Manual De Instrucciones página 5

Wall Mounting (BDH2010LP)
The product can be wall mounted, if desired,
using the wall mount bracket, screws and
anchors supplied. To wall mount the vac, refer
to figures B and C.
• Figure B - Mark the location of the screw
holes.
• Figure C - Hang the vac on the wall by
placing the opening on the base of the vac
over the hooks in the wall mount bracket.
Use
Switching on and off
• Figure D - To start, slide the On/Off switch forward
(i.e. "O"= Off, "I" = On).
• To stop, slide the switch back.
• Return the product to the charger immediately
after use so that it will be ready and fully charged
for the next use. Ensure that the product is fully
engaged with the charger base.
Cleaning and emptying the product
WARNING:
without its filter.
NOTE: The filter is re-usable, do not confuse it with a
disposable dust bag, and do not throw it away when the
product is emptied. We recommend that you replace the
filter every 6-9 months depending on frequency of use.
There are two methods of cleaning the bowl, a quick
empty method and a thorough clean method.
For a quick empty (figures E, F)
• Figure E - Press in on both nozzle release buttons on
the sides of the nozzle and remove the nozzle by pulling
straight off.
• Figure F - Empty the dust from the bowl.
• For a more thorough cleaning, remove bowl as
described in figures G, H, & I.
Projectile/Respiratory Hazard: Never use the vac
5
B
D
E
F
C