Nozzle / Accessories
• Figure K - A crevice tool is built into the nozzle
and can be extended as shown in figure K
by pulling the extension piece until it locks into
position.
• Figure L - A brush accessory is built into the
nozzle and can be flipped upwards for use.
• Figure M - The nozzle can be rotated for better
access in tight spots. To rotate the nozzle, press
the button shown in figure M and rotate the nozzle
to the left or right until it clicks into place.
Replacing the filters
The filters should be replaced every 6 to 9 months
and whenever worn or damaged. Replacement
filters are available from your BLACK+DECKER
dealer.
Visit www.blackanddecker.com to locate dealers.
• Remove the old filters as described above.
• Fit the new filters as described above.
Maintenance
Bowls and filters can be washed thoroughly;
however, use only mild soap and a damp cloth to
clean the main part of the vacuum.
IMPORTANT: To assure product SAFETY
and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual)
should be performed by authorized service centers
or other qualified service personnel, always using
identical replacement parts.
Troubleshooting
If the product does not work, check the following:
• The charger was correctly plugged in for recharge. (It feels slightly warm to the
touch.)
• The charger cord is not damaged and is correctly attached.
• The charger is plugged into a working electrical outlet.
• The switch is in the "OFF" position when charging.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK+DECKER help line at
1-800-544-6986.
Accessories
Recommended accessories for use with your product are available from your local
dealer or authorized service center. If you need assistance regarding accessories,
please call:
1-800-544-6986.
• Filter accessory number VF110.
WARNING:
this product could be hazardous.
Battery Removal and Disposal
This product uses Lithium Ion rechargeable and recyclable batteries. When the
batteries no longer hold a charge, they should be removed from the Vac and recycled.
They must not be incinerated or composted.
The batteries can be taken for disposal to a BLACK+DECKER, Company-Owned or
Authorized Service Center. Some local retailers are also participating in a national
recycling program (see "RBRC™ Seal"). Call your local retailer for details. If you bring
the batteries to a BLACK+DECKER Company-Owned or Authorized Service Center,
The use of any accessory not recommended for use with
7
K
L
M