Nikon ECLIPSE E200 Manual De Instrucciones página 71

Removal of Shipping Clamps

The stage top plate and focusing mechanism are

clamped for protection against vibration and shocks

during transportation. Remove these shipping

clamps with the hexagonal wrench provided.

• Stage Top Plate:

The top plate of the stage is retained in the

Y-axis direction by a plate fastened with two

bolts. Remove the bolts and the plate.

• Focusing Mechanism:

Remove the field lens unit to expose a plate

retaining the vertical movement of the focusing

mechanism. The plate is fastened with 3 bolts.

Remove the bolts and the plate.

Installing the Eyepiece Tube

Loosen the eyepiece tube clamp screw by hand and

place the eyepiece tube on the circular dovetail

mount. Tighten up the eyepiece tube clamp screw

by hand.

Connecting the Power Cord

Turn off the power switch of the microscope (turn to " "). Connect one end (socket) of the

supplied power cord to the AC inlet on the rear of the microscope. Connect the other end (plug)

to an AC line receptacle with the ground conductor (earth conductor). Make sure that the power

cord is securely connected.

• Note that the microscope should be installed near the AC line receptacle and the AC line

receptacle should be placed within your reach.

• Use the power cord provided. The use of other cords may damage the instrument or cause a

fire hazard.

• If using an extension cord, use only a cord that includes a protective earth (PE) wire.

This completes the assembly of the microscope standard set.

Chapter 6 Assembly

1 Assembly of Standard Set

Shipping

clamps

Eyepiece Tube

Clamp Screw