Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
• As shown in figure1, remove all
the packing materials (including
the foam base).
Upon opening of the package,
water drops may be seen on the
plastic bag and the porthole. This
is a normal phenomenon resulting
from water tests in the factory.
Water tests are conducted to check
for leakage.
• Remove three transportation bolts as shown in
figure 2A. The bolts protect the appliance
from shock during transportation. The steps below
should be followed before using the appliance:
1. Remove the back plate of the washing
machine. To remove this you must remove
three screws holding the panel.
2. Now you could remove the transportation bolts.
While removing the three bolts from the rear
of the washing machine, remove the rubber
hoses which are behind the transportation
bolts inside the unit at the same time. Remove
themetal bracket and save in a safe place for
later use.
3. Reinstall the back plate.
4. Fill the holes left by the bolts with plastic plugs.
(Attention: The bolts and rubber hose should
be kept in a safe place for later use.) (Fig. 2B)
• Leveling the washing machine: There are
adjustable feet under the bottom of the
washing machine. Before use, the washing
machine should be adjusted, as shown in
figure 3, so that it is level.
• Leveling legs can be adjusted by turning them
counterclockwise to raise your washer or
clockwise to lower your washer.
Fig. 1
Back Plate
Transportation Bolt
Fig. 2
Fig. 3
English
Metal
bracket
Screws
A
B
10
Publicidad
