Publicidad
Idiomas disponibles
Idiomas disponibles
Turn integral supply stops 90˚
for OPEN/CLOSE.
Integral Supply Stop Operation
NOTE: Use a socket wrench with 1/2" (13 mm) socket to adjust the
stops.
Turn Off the Stops
Use a socket wrench to turn the integral stops 90°
counterclockwise to close both the hot and cold water inlet
supplies.
NOTE: If the inner body turns, but the outer ring does not turn,
firmly tighten (clockwise) the integral stop. Then rotate
counterclockwise. The outer ring should then turn with the integral
stop.
NOTE: If the outer ring still does not turn, slide the locking bar up
by loosening the screw. Free the integral stops by turning them
clockwise and then turn them back to their original position. Slide
the locking bar back in place and secure with the screw.
Confirm the stops are closed using the diagram above.
Turn the volume control counterclockwise to release excess water
(not shown).
1170591-5-A
Locking Bar
Integral
Supply Stops
4
Supplies Closed
Supplies Open
Kallista
Publicidad
