Nilfisk VHS120 L Instrucciones De Uso página 30

VHS 120 L, M, H
Vacuuming of liquids (VHS 120 L)
Comply with the safety regulations governing the
vacuumed materials.
■
Make sure the liquid stop device is
working correctly before vacuuming
liquids.
■
If foam forms, turn off the vacuum
cleaner immediately and empty the
container.
■
Warning: switch off the vacuum
cleaner immediately if foam or liquid
leaks out.
■
Regularly clean the liquid level
limiting device and check to make
sure that there are no signs of
damage.
■
Warning: the dirty liquid collected
by the vacuum cleaner must be
considered conductive.
Do not use the vacuum cleaner if the liquid mechanical
stop is not installed!
If it's used without the float, the vacuum cleaner may
be seriously damaged.
When vacuuming a mix of water and air, take care to
avoid overloading the motor of the vacuum unit.
I
The machine vacuums liquids and deposits them into the
container.
When the machine vacuums liquids it must be equipped with
GB
liquid mechanical stop (11).
The liquid mechanical stop requires a special container (12)
with relevant nozzle (13).
E
Before starting the vacuum cleaner, close the upper inlet (4)
with the relevant plug (14) and fit the vacuum hose in the
relevant hose (13), then fit the required tool on to the end part
E
of the hose (Refer to the manufacturer's accessory catalogue
or Service Centre).
The liquid mechanical stop (11) stops the vacuuming
operation (the vacuuming units remain activated) when the
liquid container (12) is full; it is then necessary to turn off the
vacuum cleaner and empty the liquid container (12).
The vacuum cleaner does not switch off automatically.
C438
WARNING!
WARNING!
WARNING!
WARNING!
Figure 1
Maintenance and repairs
WARNING!
Disconnect the vacuum cleaner from its
power source before cleaning, servicing,
replacing parts or converting it to
another version/variant, the plug must
be disconnected from the socket.
■
Carry out only the maintenance operations
described in this manual.
■ Use only original spare parts.
■ Do not modify the vacuum cleaner in any way.
Failure to comply with these instructions could
jeopardize your safety. Moreover, such action would
immediately make the EC declaration of conformity
issued with the vacuum cleaner void.
WARNING!
For maintenance procedures not described in this
manual, please contact the manufacturer's technical
support or sales network.
8
07/2018