Safety and operating instructions
Overview
To reduce the risk of serious injury or death
to yourself or others, read the Safety
instructions section found on the previous
pages of this manual before operating the
machine.
Design and function
These instructions are valid for the CP 0017 SVR.
The CP 0017 SVR is a machine with a vibration
damping D-handle, designed for light demolition
and plant work. The machine can be used both
horizontally and vertically. No other use is permitted.
To choose the correct insertion tool, see the spare
parts list.
Choosing the correct
pneumatic hammer for a
task
It is important to choose the correct size of
pneumatic hammer for the work to be performed.
A pneumatic hammer that is too small means that
the work will take longer.
A hammer that is too big means that there must be
frequent repositioning, which is unnecessarily tiring
for the operator.
A simple rule for choosing the correct size of
pneumatic hammer is that a normal sized piece of
broken material should be removed from the
workpiece within 5–10 seconds operation.
>
If it takes less than 5 seconds a smaller pneumatic
hammer should be selected.
>
If it takes more than 10 seconds a larger
pneumatic hammer should be selected.
12
Main parts
A
B
E
F
C
Handle
A.
Trigger
B.
C.
Tool retainer
D.
Air inlet
Muffler
E.
Cylinder
F.
G.
Housing
Labels
The machine is fitted with labels containing
important information about personal safety and
machine maintenance. The labels must be in such
condition that they are easy to read. New labels can
be ordered from the spare parts list.
Data plate
A
C
B
Machine type
A.
Maximum permitted compressed air pressure
B.
Serial number
C.
9800 0621 90e | Original instructions
CP 0017 SVR
D
G
E
D