Publicidad
Idiomas disponibles
Idiomas disponibles
CP 0017 SVR
Periodic maintenance
After each operating period of approximately 100
impact hours or three times a year the machine must
be dismantled and all parts be cleaned and checked.
This work must be performed by authorized staff,
trained for this task.
As a guideline, to maintain a high output the parts
in the table must not be worn more than the
dimensions stated. Note that the CP 0017 SVR does
not have air cushion damping of the piston. This
means that the damping ability cannot be used to
determine the degree of wear on the piston and
cylinder.
Max. inner
Part
diameter mm (in.)
Cylinder
28.63
(1.13)
Piston
-
Assembly instructions
C
F
E
Torque: 65-70 lbf/ft (88-95 Nm), use Loctite®
A.
243™ (Loctite is a registered trademark of
Henkel Corporation. 243 is a trademark of
Henkel Corporation.)
B.
Torque: 11-12 lbf/ft (15-17 Nm), UNF
44 (1-
3
⁄
in.)
4
C.
Torque: 11-12 lbf/ft (15-17 Nm), UNC
x 32 (1-
1
⁄
in.)
4
Torque: 12 lbf/ft (17 Nm), use Loctite® 243™,
D.
M6 x 40 - 12.9
Do not lubricate support rolls, wear ring or
E.
corresponding contact surfaces.
9800 0621 90e | Original instructions
Min. outer
diameter mm (in.)
-
28.50
(1.12)
B
A
D
1
⁄
in. x
4
1
⁄
in.
4
Safety and operating instructions
F.
Remove the O-ring from the seal before
assembly. The O-ring is only a support to
ensure that the seal retains the correct shape
until it is fitted.
Troubleshooting
If the pneumatic machine does not start, has low
power or uneven performance, check the following
points.
Check that the insertion tool being used has the
♦
correct shank dimension.
Check that the pneumatic machine is getting the
♦
correct amount of lubricant. Too much lubrication
can cause starting problems, low power or
uneven performance.
Check that the compressed air system supplies
♦
the machine with sufficient air pressure to give
full power.
Check that the dimension and length of the air
♦
hose are according to the recommendations. See
"Installation".
If there is a risk of freezing, check that the
♦
machine's exhaust ports are not blocked.
If the machine function is still not satisfactory after
♦
this procedure, contact an authorised service
workshop.
Storage
>
Clean the machine properly before storage, in
order to avoid hazardous substances. See "Dust
and fume hazard"
>
Pour approximately
1
⁄
2
the air inlet nipple, connect the machine to the
compressed air supply and start it for a few
seconds.
>
Always store the machine in a dry place.
Disposal
A used machine must be treated and disposed of in
such a way that the greatest possible portion of the
material can be recycled and any negative influence
on the environment is kept as low as possible, and
in respect to local restrictions.
oz (5 cl) of oil directly into
17
Publicidad
