CP 0017 SVR
CP 0017 SVR hexagon
A
1. Place the buffer (A) over the stem of the insertion
tool.
2. Place the retainer over the hexagon body of the
insertion tool.
3. Insert the insertion tool into the cylinder and
screw the retainer onto the cylinder until it is
locked.
CP 0017 SVR hexagon
with optional quick release retainer, see the
spare parts list.
1. Unscrew the retainer approximately 2.5 turns.
2. Insert the insertion tool into the retainer.
3. Screw the retainer onto the cylinder thread with
hand force, ensuring that the insertion tool shank
enters the cylinder.
4. The assembled inserted tool is centered in the
cylinder.
Operation
WARNING
Involuntary start
Involuntary start of the machine may cause injury.
Keep your hands away from the start and stop
►
device until you are ready to start the machine.
Learn how the machine is switched off in the event
►
of an emergency.
►
Stop the machine immediately in all cases of
power supply interruption.
9800 0621 90e | Original instructions
3
x 2 in. (19 x 50 mm).
4
3
x 2 in. (19 x 50 mm)
4
Safety and operating instructions
Start and stop
Start the machine by squeezing the trigger while
firmly holding the handle.
Stop the machine by releasing the trigger. The
trigger returns automatically to the stop position.
Operating
Starting a cut
♦
Stand in a stable position with your feet well away
from the inserted tool.
Press the machine against the working surface
♦
before you start.
Start collaring at such a distance from the edge
♦
that the machine is capable of breaking the
material without levering.
Never try to break off too large pieces. Adjust the
♦
breaking distance (A) so that the inserted tool
does not get stuck.
A
15