Description Of The Appliance - Oster OMF831 Manual De Instrucciones

2 - DESC RIPTIO N O F TH E APP L I AN CE
1 2
11
12
14
15
16
1. Front grill
2. Blade nut
3. Fan blades
4. Rear grill attaching nuts (4)
5. Rear grill
6. Motor housing screw
7. Motor housing
8. Speed control
9. Height adjustment thread
10. Base cover
3 4 5 6 7
8
9
10
13
17
18
19
20
11. Air Circulator Screw Support (Left)
12. Air Circulator Screw Support (Right)
13. Air Circulator Screw & Nut Set
14. Air Circulator Base (Left)
15. Air Circulator Base (Right)
16. Air Circulator Base (Front)
17. Column
18. Air Circulator Base Screw (2)
19. Base Screw & Nut Set (4)
20. Base
ENGLISH-3
3 - ASS EM BLY
TO BE USED AS A STAND FAN
1. Place the base of the fan on the floor and insert the shaft to
it. Attach the shaft onto the base with the four screws and nuts
included with the unit. Tighten the screws until the nuts are inside
the wells under the base (see figure 1).
2. Place the cover onto the base (see figure 2).
3. Slide the height adjustment nut down the shaft and adjust the
upper part of the shaft to the desired height and then turn the nut
to tighten it (see figure 3).
4. Then place the motor head onto the top of the shaft and tighten it
using the thumb screw (see figure 4).
5. Place the rear grill on the motor head making sure the small hole
on the grill is on the bottom. Attach the rear grill using the four
screws that come with the unit (see figure 5).
6. Insert the fan blade making sure the notch is lined up with the
peg in the motor head shaft then screw in the fan bade lid nut
counterclockwise until it is tight (see figure 6).
7. Slide in the front grill by the locking tabs making sure the Oster
logo is straight (see figure 7).
8. Slid in the control switch onto the back of the motor head.
ENGLISH-4
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
small hole
on bottom
Fig. 6
Fig. 7