Oster OMF831 Manual De Instrucciones página 7

Ventilador 3 en 1 de 18
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TO BE USED AS A TABLE FAN
1. Assemble the small stand using the screws provided as indicated
(see figure 8).
2. Place the two brackets onto the sides of the base of the motor
head as indicated. The bracket that has a bend portion should go
onto the side where it fits in (see figure 9).
3. Place the small stand and attach it with the Air Circulator Screw
& Nut Set (see figure 10).
TO BE USED WALL MOUNTED
1. Use regular screws to attach the wall mounting stand onto the
wall ensuring to use the appropriate screws and anchors to fix it
safely into place in the type of wall of your home.
Fig. 8
Fig. 9
Fig. 10
Fig. 10
ENGLISH-5
4 - OPER ATING INS TRUCTIONS
Attention! Plug unit to a wall electric outlet with the same voltage of the one from your unit.
Ensure that the fan is mounted and placed on a flat, sturdy and dry surface. Turn the on/off dial to
the preferred speed and then plug into the electrical outlet. Switch unit on by pressing the desired
speed button.
4.1CM
2
1
0
[Figure 7]
0.5CM
1 - Off Setting
2 - Eco Mode
3 - Night Mode
4 - Max
Your fan can operate fixed in one position or oscillate, distributing
the air through the environment. To turn on and off the oscillation,
simply tighten/pull the oscillation pin.
5.3CM
3
ECO
E C O
4
MAX
MAX
0.9CM
11
[Figure 12]
ENGLISH-6

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido