Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
Mounting the door
Insert the door at an ap-
1
proximate angle of 45° until
you feel that it comes in
contact with the frame of
the range.
Lower the door as if you
2
were going to open it
completely, and carefully
unhook the locks.
Fully close the door. You will
3
hear a slight click indicating
that the door is correctly
mounted.
WARNING: WHEN HAVING
THE DOOR OUTSIDE THE
RANGE, DO NOT RELEASE
THE LOCKS FOR ANY
REASON AS THE MAIN
ARM WILL SNAP BACK
AGAINST THE DOOR.
2.9 Installing oven racks
The oven racks are designed with a
stop lock that prevents them from
tilting and completely coming out.
This is especially convenient when
placing or removing food from the
oven.
To remove oven racks, slide them
towards you, lift up the front end
and pull out.
To replace them, place the rack on
the rack support (the curved part of
the rack should face toward the rear
of the oven and under the stop). Tilt
up the front and push the rack inside
the oven until it goes past the bump
on the oven wall.
Next, lower the front and completely
slide the rack to the back of the
cavity.
The oven has four rack positions as
illustrated in the diagram. The
"Cooking recommendations"
section has a detailed explanation on
the use of each rack position.
Back Wall
Gliding rack (on some models).
To get a proper operation, make sure
the gliding rack is correctly installed
by following the next two steps:
59
D
C
B
A
Publicidad
