Tripp-Lite U203-004-R Manual Del Usuario página 3

Installation
1. Plug the B type connector into the upstream port (Root port)
of the HUB (1)
2. Plug the A type connector into the Host (PC)
3. Connect all USB Devices to the HUB Host (2)
WARNING: You cannot connect another hub to this one. You
can, however, connect this hub to any self-powered hub to
increase the number of ports.
1
2
A Connector
B Connector
Overcurrent
An unlit port LED indicates a problem has been detected
and the port has been deactivated. Disconnect the device
connected to the Port. The Port will unlock only when the
HUB is shut down and restarted. Try reconnecting the
device. If the port LED turns off again, have the device
checked.
3