Eaton LuxeScape Instrucciones De Instalación página 2

Installation Instructions – LuxeScape Collection Accessories
INSTALLATION
This lighting fixture has been shipped complete with one
of several mounting options. Please follow the installation
instructions specific to the catalog part that you ordered.
N ote: Care must be taken not to set lighting fixture down
on optical lenses or lift the fixture in the lens area.
N ote: A 3" – O.D. Tenon is required to install the double
arm post top accessory. If installing on a pole with
a 2-3/8" tenon, use accessory PN: ARPA2 and
instructions titled, "TENON SLEEVE INSTALLATION, "
at the end of the instructions.
To Install Post Top Double Arm Accessory
Tools Required
3/16" hex bit, Torque wrench that measures up to 200 in-lbs
minimum.
1. Loosen the captive screw and take off the cap.
(Figure 1.)
2. Pull supply wires from post through the hole originally
covered by the cap.
3. Pull all leads from the pole and both arm wings out of
the hole. (Figure 2.)
4. Slip fit the arm onto the tenon.
5. Rotate the arm to desired position.
6. Tighten all eight (8) 3/8 – 16 set screws (provided) to
180 in-lbs. (Figure 3.)
7 . In the same order as step 6., torque all 8 setscrews to
200 in-lbs.
8. Connect leads properly.
9. Push wires back into the hole.
10. Use installation instructions provided with luminaire to
mount both fixtures onto the arm, one on each wing.
11. Close the hole with cap.
To Install Wall Mount Arm Accessory
Tools Required
Silicone caulk, 3/4" socket, Torque wrench that measures
up to 40 ft-lbs minimum (480 in-lbs), 3/16" hex bit, Torque
wrench that measures up to 200 in-lbs minimum.
1. Using wall mount plate as a template and drill (6)
holes. (Figure 4.) Install appropriate wall anchors (not
supplied) Silicone caulk around junction box and wall
anchors. Secure wall mount plate to wall with (6) ½-13
x 1-1/2 long bolts and six (6) lock washers. Torque bolts
to a minimum 37 ft-lbs. to secure accessory- see note
below.
2
EATON
IB500012EN Installation instructions
Figure 1.
Figure 2.
Figure 3.
J-Box
Wall
Anchors
Wall
Figure 4.
Cap
Leads
3/8" Set Screw (8
Places)
Wall Mount Plate
Lockwashers
Bolts
Wall Mount Arm
3/8" Set Screw