Publicidad
Idiomas disponibles
Idiomas disponibles
Multilaser Silver
• MP3 crosstalk: > 55 dB
• MP3 SNR S/N: > 60 dB
• FM crosstalk: >35 dB
• FM signal-to-Noise S/N: > 50 dB
• FM sensitivity: 30 dB S/N < 9dB
• Voltage: 12V DC car battery (the cathode is earthed))
• Current sinking: maximum - 15A (12V)
• Maximum output: 45W 4x
• Number of tracks: quadriphony
FM information
• Frequency coverage: 87,5 MHz ~108 MHz
• Usable sensitivity: 3uV
• IF (intermediate frequency): 10,7 MHz
• RCA Line Output (option)
• Output 1200 Mv (MAX)
• Playing MMC/SD and USB
• MP3 Sound System
• Frequency: 20 Hz ~ 20 kHz
• Signal to noise (MMC/SD and USB): 50dB (1 kHz)
1. A tube fuse is installed the red wire (Power) and 12V/15A tube fuse is installed in yellow wire (Battery).
Therefore, replace tube fuses according to the requirements.
15
Explanation for Installation
Please refer to Installation Drawing.
Power Supply and Polarity:
The anode should be connected with the anode of car battery and the cathode should be earthed (the
cathode of battery or body frame).
Note: To avoid any short, please connect the cathode of battery after finishing installation.
The Installation of Metallic Sheath
• Install metallic sheathes on the instrument panel (see Installation Drawing I).
• Fasten a metallic sheath on the instrument panel and remove the card on the metallic sheath with a
driver to fasten the metallic sheath.
The Connection of Power Supply
• Red (ACC wire): Connect it with the anode in 12 V constant voltage (it is controlled by ignition device of
the car);
• Yellow (Power cable): Connect it with the 12 V power switch (the power is for the player's memory).
Publicidad
