Replacing The Main Filter - Nilfisk cfm A15EXP Manual De Instrucciones

REPLACING THE MAIN FILTER

1. Release the latches "A" and remove the Venturi power-head "B" (Figure 3).
2. Raise one side of the filter and reach down under the filter
with one hand to remove split pin "D". This will release
the filter shaker lever "E" from the filter ring "F" (Figure 5).
3. Lift up of the filter and cut the ties (G) that attach the filter
to the ring "F"(Figure 5).
4. Unscrew clamp "H" and remove the upper ring "I" (Figure 4).
5. Mount the upper ring "I" onto the new filter and secure
the ring in place with clamp "H" (Figure 4).
6. Secure the Filter "C" to the ring "F" using the ties "G"
supplied in the new filter kit (Figure 5).
7. Place the new filter assembly inside the filter chamber and
reconnect the assembly using the split pin "D" (Figure 5).
8. Mount the suction unit "B" onto the machine and secure
in place with the latches "A" (Figure 3).
9. Dispose of the old filter in accordance with all federal,
state and local regulations.
INSTRUCTIONS FOR USE
3
3
4
5
PAGE 6